3. Mould


When you select Ryman Composites to assist or manage your project, depending on your stage of development you can engage with us at any phase of the process.

Our project map starts with design and works through the other stages. See below for the Mould Design and Mould Manufacture Component stages that we believe should be considered and incorporated into a complete project flow:

Work from this stage assumes that a fully finished and dimensionally stable pattern exists, is checked and aproved and is of mould production quality.

Mould Design

    • Open mould - Hand-layup 
    • Open Mould - Chopper-gun 
    • Closed Mould - RTM Lite Infusion 
    • Single mould 
    • Split mould 
    • Multi-part mould 
    • Rigid or Flexible mould 
    • Closed mould 
    • Heated 
    • Cooled 
    • Gimbaled 
    • Mould Cost Review 

Moulding 

    • Surface Plug to final finish 
    • Flange design 
    • Split location 
    • Frame design 
    • Material selection 
    • Mould laminate specification 
    • Mould manufacture 

Read more about Design > Plug > Mould > Part ...

Comments